1965-70 Mustang V8 MRT ChamberFlow Cat Back - 2.5" pipe

The Mustang V8 2.5" MRT ChamberFlow After Manifold Exhaust system has a loud, deep muscle car sound and is constructed in corrosion-resistant T304 Stainless Steel. This system is made from T304 stainless steel 2.5" tube with mandrel bending and includes 2 exhaust tip types: angle cut for the GT rear fascia and turn down tips for other applications. This system is engineered for the best sound to match the Mustang American icon and provides increased performance from the increased exhaust flow. The MRT ChamberFlow is louder than the MaxFlow system. There's no engine sound quite like the rumble a muscle car makes and this MRT exhaust system delivers a low deep sound reminiscent of the 1960s and 1970s muscle cars.

Application:
All hardtop, fastback, and convertibles for First Gen Ford Mustangs with V8 engines. Reference Technical Specs for detailed body styles supported.

Note: Due to production variability at the time these vehicles were produced, a "perfect" fit is not guaranteed.
MRT mastered this configurationon 289 engine manifold configuration. In all other engine configurations, the lead tubes may require minor modification to fit at the manifolds. Call us if you have questions.

Hear the Difference

• How does it sound? MRT ChamberFlow After Manifold Exhaust has a classic, deep American muscle car sound.
• Is there drone or resonance? The drone is noticeable but tolerable.
• What if I step on it? Wide-open throttle increases exhaust loudness to an aggressive performance sound.

Are you located close to Plymouth, MI and need your MRT aftermarket exhaust installed? Call MRT at 734-455-5807 to make an appointment today!

Application:

• 1964-½,1965, and 1966 Mustang with 260 and 289 V8 engines.
• 1965 and 1966 Shelby Mustang GT350.
• 1967 and 1968 Mustang with 260, 289, 302, 390, 427, and 428 V8 engines.
• 1968 Mustang California Special (GT/CS) and High Country Special with V8 engine.
• 1969 and 1970 Mustang with 302, 351, 390, 428, and 429 V8 engine.
• All hardtop, fastback, and convertibles for First Gen Ford Mustangs.

Note: Due to production variability at the time these vehicles were produced, a "perfect" fit is not guaranteed.
MRT mastered this configuration on 289 engine manifold configuration. In all other engine configurations, the lead tubes may require minor modification to fit at the manifolds. Call us if you have questions.

Tune: None required
Time to Install: 3-4 Hours

Engineered Design

• Manifold back exhaust system made from 2.5" T304 stainless steel
• Chambered muffler for old school, deep, throaty American exhaust sound
• Straight through turn down tips and polished tips included

Product Quality

• Exhaust is designed and handcrafted in-house at MRT facility in Plymouth, Michigan, USA.
• A limited Limited Lifetime Warranty is given for every exhaust system.

---

---