1966-70 Mustang V8 MRT ChamberFlow Cat Back Exhaust

The Mustang V8 3" MRT ChamberFlow Cat Back exhaust with turn down tips has a loud, deep rumble sound and is handcrafted in corrosion-resistant T304 Stainless Steel. Base systems include turn-down tips to not be super visible and 3" mandrel-bent tube for improved exhaust gas flow. This system is engineered for the best sound to match your Mustang with an American muscle sound. The MRT ChamberFlow is louder than the Street Race system. It has just enough exhaust presence with elevated sound to Get Noticed, Feel the Performance note, and packaged in a design without the excessive drone.

What's included?

• Mid pipe exhaust with H-pipe design
• Mufflers and connection exhaust tubes
• Over Axle back tubes and turn down tips
• Hardware including clamp, hanger isolators and gaskets
• NOT INCLUDED: 3" tubes at manifold connection as there were no stock OE 3" exhaust options back in the day

Application:
All hardtop, fastback, and convertibles for the First Gen Ford Mustang with V8 engines. Reference Technical Specs for detailed body styles supported.

Note: Due to production variability at the time these vehicles were produced, a "perfect" fit is not guaranteed.
Manifold lead tubes are not included in this kit. Some fabrication required.

Hear the Difference

• How does it sound? The MRT Mustang V8 3" Chamberflow Cat Back has an aggressive, deep rumble.
• Is there drone or resonance? The drone is noticeable but tolerable.
• What if I step on it? Wide-open throttle increases exhaust loudness to an aggressive performance sound.

Are you located close to Plymouth, MI, and need your MRT aftermarket exhaust installed? Call MRT at 734-455-5807 to make an appointment today!

Application:

• 1964-½,1965, and 1966 Mustang with 260 and 289 V8 engines.
• 1965 and 1966 Shelby Mustang GT350.
• 1967 and 1968 Mustang with 260, 289, 302, 390, 427, and 428 V8 engines.
• 1968 Mustang California Special (GT/CS) and High Country Special with V8 engine.
• 1969 and 1970 Mustang with 302, 351, 390, 428, and 429 V8 engine.
• All hardtop, fastback, and convertibles for First Gen Ford Mustangs.

Note: Due to production variability at the time these vehicles were produced, a "perfect" fit is not guaranteed.
Manifold lead tubes are not included in this kit. Some fabrication required.

Tune: None required
Time to Install: 90 Minutes

Engineered Design

• Manifold back exhaust system made from 3" T304 stainless steel
• Chambered muffler for old school, deep, throaty American exhaust sound
• Turn down tips and slant cut polished tips included

Product Quality

• Exhaust is designed and handcrafted in-house at MRT facility in Plymouth, Michigan, USA.
• A Limited Lifetime Warranty is given for every exhaust system.